STAND UP THE FRAME BY THE FEET.

**NOTE – DO NOT TIGHTEN DOWN BOLTS UNTIL STEP 6 ** 

BOLT EACH LOWER LEVELER LEG ON THE BACK SIDE OF THE FRAME USING THE ½" X 6 ½" BOLTS.

– MAKE SURE THE LEVELER IS FACING DOWN. -

BOLT THE UPPER LEGS TO THE LOWER LEGS (FORK END DOWN) USING ½” X 4” BOLTS,

THEN BOLT THE LEG TO THE TOP OF THE BACK SIDE OF THE FRAME USING THE ½" X 6 ½" BOLTS. 

BOLT THE MIDDLE LEG SUPPORT TO THE UPPER & LOWER LEGS USING ½” X 4” BOLTS. 

LEG ADAPTERS (IF APPLICABLE) - ATTACH THE LEG ADAPTERS USING 3/8” X 3 ½" BOLTS 

TIGHTEN ALL BOLTS – USE THE LEG LEVELERS TO ADJUST PITCH. (SAME ON BOTH SIDES) 

PUT WHEELS ONTO THE ARMS AND INSTALL THE ARMS INTO THE FRAME (20 ARMS TOTAL) -

INSERT THE ARMS INTO THE FRAME ARM HOLES BY SLIDING UP THEN DROP DOWN INTO THE BOTTOM HOLE 

​

*** PROVIDED HARDWARE – SIZE 9X6 / 11X8 / 12X9 - FRAME/LEG BOLTS - (4) 1/2" X 6 ½”  - (6) 1/2" x 4” BOLTS  - (10) 1/2" NUTS & WASHERS – LEG ADAPTER BOLTS (8) 3/8” X 3 ½" BOLTS - (8) 3/8” NUTS AND WASHERS - 20 BLACK WHEELS – RUG CLIPS *** 

​

NOTE – THE ZUES 20 ARM UNIT PICTURED BELOW IS SHOWN WITHOUT LEG ADAPTERS